BL2.ru

Local resistances: ζ coefficients reference (Idelchik), minor head loss and equivalent length

Pick a pipe element - a sudden expansion or contraction, an elbow, a gate valve, a tee - and get the coefficient ζ. With a diameter and a flow it also gives the head loss, the pressure drop and the equivalent length of straight pipe.

The sudden expansion and contraction are computed from formulas and refer to the velocity in the narrow pipe. The other values are typical reference numbers for turbulent flow: for a design check the diagrams of the Idelchik handbook. The same ζ are used on the pipe head loss page.
Calculate

What is a local resistance

At bends, in valves and where the section changes the flow separates from the walls, eddies form and some of the energy is lost on a short stretch. The head loss is expressed through the velocity head: h_m = ζ·v²/(2g). The coefficient ζ depends on the shape of the element and, weakly, on the Reynolds number. It is important which velocity it refers to: for an expansion and a contraction it is the velocity in the narrow pipe.

Sudden expansion and contraction

For a sudden expansion the loss follows from the momentum equation (the Borda - Carnot formula): ζ = (1 − F₁/F₂)², that is h_m = (v₁ − v₂)²/(2g). For a sudden contraction the Idelchik handbook gives, for turbulent flow (Re > 10⁴), ζ = 0.5·(1 − F₁/F₂)^0.75. These are the two formulas of the page: they are exact, and their graph is shown under the drawing. Textbooks sometimes use the simpler ζ = 0.5·(1 − F₁/F₂); the results are close.

Typical values

The other coefficients in the table are rounded typical values for turbulent flow: a sharp-edge entrance 0.5, an exit into a tank 1, a sharp 90° elbow about 0.9, a smooth bend about 0.3, an open gate valve about 0.15, a globe valve about 4.5, a check valve about 2.5. They are marked as reference: for real products the values change by a factor of 2-3 with the design, the bend radius and the opening. For a design use the diagrams of the Idelchik handbook or the manufacturer data.

Equivalent length

The loss in an element can be replaced by the loss in a straight pipe of length L_eq = ζ·d/λ, which is handy for adding local and friction losses. Coefficients are added when they refer to one velocity; for different sections they are converted to the velocity of the section considered.

Source: Idelchik I. E. Handbook of Hydraulic Resistance, 3rd ed., 1992. Also: Chugaev R. R. Hydraulics.

FAQ

How do I calculate the loss in a local resistance?
h_m = ζ·v²/(2g), where v is the velocity the ζ refers to. Multiply by ρg to get the pressure drop.
Which velocity does ζ refer to for an expansion and a contraction?
In the Idelchik handbook it is the velocity in the narrow pipe. To refer the loss to the wide pipe velocity multiply ζ by (F₂/F₁)². The calculator shows both values.
Why does a sudden contraction lose less than an expansion?
In a contraction the flow accelerates smoothly and the loss comes from the vena contracta at the entrance of the narrow pipe. In an expansion the jet is slowed by eddies and loses the whole difference of velocity heads.
Can I trust the ζ table for valves?
As a guide. The values are rounded and typical, and real products differ. For a design use the valve data sheet or the handbook diagrams.
What is the equivalent length?
The length of straight pipe with the same loss as the local resistance: L = ζ·d/λ. It is added to the pipe length so that all losses are computed by the single Darcy - Weisbach formula.